San Jose Navigation CT-58 Betriebsanweisung PDF herunterladen (Seite 8)

5. Setup

CT-58A currently provides 13 commands for setup. You can setup the CT-58A by following the instructions shown

in this chapter via SMS from a cellular phone. Key the specific SMS message in your cellular phone as the

instruction and send it to the SIM number of CT-58A. The setup messages are showed in the following sections.

Note1: The default settings are shown as below.

a. Default CT-58A ID is “username”, and please read Chapter 5.1 in order to change the ID.

b. Default password is “0000”, and please read Chapter 5.2 in order to change the password.

c. There’s no number in the default

contact, and please read Chapter 5.5 in order to add the phone

number.

Default setting of Auto Report is deactivated, and please read Chapter 5.6 in order to setup the auto

regular report.

e. Default setting of APN is only suitable for Taiwan GSM netw

ork and please read Chapter 5.3 in order

to change the APN.

f. Default setting of IP/domain is http://www.sanav.com/eric-gga/gprs.aspx

and please read

Chapter 5.4 in order to change the IP/domain.

g. Please be aware of the upper and lower cases when you send the SMS command to CT-58A.

Note2: Before doing any setup, please ensure CT-58A

is connected with the GSM network. The red LED must

lights on. And please note that CT-58A must not be under Panic mode.

Note3: While you are keying in any setup message, note that NO space is allowed between the characters in

the SMS. Characters can be letters, commas or any signs.

Note4: Any setup message must be started with a “#” sign and ended up with a “*” sign.

Note5: Only when the password, username and setup message are correct, the CT-58A

will update information

according to user’s definition. If the command is not valid, a failure report is going to be sent to the

commander cell phone.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Keine Kommentare

San Jose Navigation CT-58 Betriebsanweisung Seite 8