San Jose Navigation GPS Mobile Locator GM-158-USB Bedienungsanleitung PDF herunterladen (Seite 9)

www.malags.com

Connect the power cable to the other outlet in the battery box (Figure 2.6).

If a RTC is used the power cable is connected to the battery pack on the

RTC, see Chapter Batteries.

Finally, connect the encoder cable to the control unit (Figure 2.7).

Fig. 2.7. Encoder cable to the control unit.

Note! The precision of the encoder wheel is not infinite and depending on

several factors as; the measurement surface, the pressure applied on the

wheel and possible wear. If you are unsure of the encoder wheel precision

a re-calibration should be made. Contact you supplier.

2.3 Start up and Power buttons

Start the Easy Locator by pressing the start button on both the control unit

and the monitor (Figure 2.8). The light in the centre of the button on the

control unit will start to blink. During the measurement the button will

remain illuminated continuously.

Fig 2.8. Start button on the control unit (left) and the monitor (right)

To turn the Easy Locator off, push the button and release quickly. The red

light will then stop blinking and the unit will be turned off with a click sound.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 38 39

Keine Kommentare

San Jose Navigation GPS Mobile Locator GM-158-USB Bedienungsanleitung Seite 9